Black DNA 30 Box Mod By HCigar

Availability: In stock (6)
Delivery time: Ships Next Business Day
This is a HCIGAR DNA30 Box mod. This version is superior to the Cloupor version in almost every way. Solid construction and machine work, no bugs or "revision" batches to be sent out. HCIGAR does not use its customers as beta testers!
 
 
Output Power - 7w-30w
Output Voltage - 4v-8.3v
Resistance - As low as 0.5ohms!
 
 
USER GUIDE
 
Locked mode
Pressing the fire button five times with less than .7 seconds between presses will cause 
the device to enter Locked mode. In Locked mode, the device will not fire and the output power will not 
adjust accidentally. While in Locked mode, the screen will be off, except that pressing a button will show 
“Locked, Click 5X”. To exit Locked mode, press the fire button 5 times. 
 
Stealth mode
While locked, holding the fire and down buttons simultaneously for five seconds will 
switch to stealth mode. In this mode the display is off. It will still show error and lock messages. To 
switch back to normal display mode, hold down the fire and down buttons simultaneously for 5 seconds. 
This setting is stored to internal flash memory, and remains if power is removed. 
 
Power Locked mode
 Holding down both the up and down buttons for two seconds will place the device 
in Power Locked mode. In this mode, the mod will operate normally, but you will not be able to change 
the power setting. This mode prevents accidental power level changes due to the buttons being pressed 
while in a pocket. To exit Power Locked mode, hold the up and down buttons for two seconds. 
 
Auto power down 
The screen will be at full brightness while firing. After 15 seconds with no button presses, the screen will 
dim. 2 minutes after the last button press, the screen will fade out and the device will go to sleep mode. 
Pressing any button will turn the device and display back on. 
 
The screen will be at full brightness while firing. After 15 seconds with no button presses, the screen will 
dim. 2 minutes after the last button press, the screen will fade out and the device will go to sleep mode. 
Pressing any button will turn the device and display back on. 
 
Error Messages 
 
Check Atomizer
The DNA does not detect an atomizer, the atomizer has shorted out, or the atomizer 
resistance is incorrect for the power setting. 
 
Shorted
The atomizer or wiring are short circuited. 
 
Check Battery
The battery is below 3.1 volts. It probably needs to be charged. 
 
Weak Battery
The battery sags excessively when firing. This typically means the user is not using a high 
rate battery, or the battery is old and degraded. It can also mean the battery is not making good contact. 
Too Hot: The DNA 30D has onboard temperature sensing. It will shut down and display this message if 
the internal board temperature becomes excessive. 
 
Too low power setting
The DNA 30D puts out a minimum of 4 volts. With low power settings (7 to 8 
watts) and low resistance atomizers (below 2 ohms) the DNA will sometimes be unable to provide a low 
enough power output to be power regulating. If this is the case, the Ohms display will be flashing. The 
device will still operate. 
 
Device resets
If the battery is not able to power the device at the desired setting, or the battery is 
excessively discharged, the device may go immediately into a low voltage shutdown. If firing the device 
causes the screen to blank out and then display the welcome screen, you should charge, replace or 
upgrade your battery. This is especially common at power settings above 20 watts. 
0 stars based on 0 reviews